Table Top

In this video I make a Table Top with a launcher ring.
Hi my dear friends! I had in mind this project for quite some time and a few weeks ago I saw in a German channel about wood working and wood turning, that motivated me to finally do it.

The following is the link to the video I saw:
https://youtu.be/tvMi46Ngjtg

In that video, the wood turner made a ring to launch the top and the top itself. I thought it would be convenient to add a handle to the launcher ring to be able to hold it firmly when you pull the rope. Also, I made a bead at the bottom of the shaft to avoid the body of the top to get stuck in the holes of the launcher ring.

I am going to put next the link for the Spanish version of my video.
Para las amigas y amigos de habla hispana, a continuación aparece el enlace de mi video en Español:
https://youtu.be/0ls-PHrSy88


I hope you enjoy this video and if that is the case, please make comments, give it a "like" and subscribe to my channel. When subscribing do not forget to activate the bell so that every time I upload a new video you will receive a notification.

If for any reason you did not like it, or there is anything that I could do better, I would appreciate that rather that giving a thumbs down, send me an e-mail to the address that appears below. I accept constructive criticism and there is always room for improvement!

The music was obtained from a royalty free sites that allows its use in videos.

From www.youtube.com/audiolibrary/music:

"Fuzzy and True" The Mini Vandals
"The Closing of Summer" Asher Fulero
"Butterflies in Love" Sir Cubworth
"Away" Geographer
"Beneath the Moonlight" Aaron Kenny
"Bellissimo" Doug Maxwell
"Baroque Coffee House" Doug Maxwell & Media Right Productions
"Eine Kleine Nachtmusik" Wolfgang Amadeus Mozart


Thank you so much for watching!!

Cheers!!

Daniel

[email protected]

Disclaimer:
You, and only you, are responsible for your safety in the shop and for your health. The procedures shown in this video, (and my answers to the comments), although they are the ones I consider safe, are not necessarily so for every operator (wood turner, carpenter, etc.). Wood is a heterogeneous and unpredictable material, not two pieces are identical, even when they come from the same trunk of the same tree, shop tools and machines can cause damage to the operator, dust and other physical and chemical contaminants may cause disease and disorders when the operator does not take into consideration adequate protection. Always read operation manuals for your tools and machinery. This video can give you a point to start your research on what is the best for you, but, in any way is the only source of information. The level of experience of the operator is also a factor; procedures that may be safe for an operator that has a lot of experience may not be dangerous for an operator with less experience. If you do not feel safe or confident with a procedure you have seen in my channel, do not repeat it. Be safe and enjoy these activities.