Making Custom Clock ( Arduino based , PCBway.com)

Let's try PCBway service!! ( https://www.pcbway.com/)
I created this desk clock. I used sevensegment display and DS3231 RTC, i used ATMega328 that I took from Arduino Uno after sketch was uploaded.

For the first time I used PCBway service. I orderd my pcbs very easy and as new customer i recived this first order for free. I payed only shipping cost which was 8 american dollars. My location is Croatia. So i got this 10 beaudiful pcb for only 8 dollars.

I dont need so many clocks so i will giveaway cople of these boards. If you want this pcb please subscribe to this chanell and leave comment below. After couple of days i will rendomy secelct winer and contact him for adress.

Pcbway is great service and quality is very nice, they are also cheaper then others services. And if you are new customer you can get first 10 pcbs free. I highly recomend it.

Download code:
https://drive.google.com/open?id=1fnA_wb_JQxn28t-SchXJ1z7Z8lJZDlzU

Download Gerber:

https://drive.google.com/open?id=1Mym0jV4ss_nwLCY3icjm8KZvPsZfM5Ct

Part list:
1x Atmega328 microcontroller
4 digits seven segment display x1
DS 3231 RTC x1
4x 330 ohms resistors –under seven segment display
1x 10K resistor (regular) x1 (on reset pin of MCU)
2x 10K resistors SMD 0805 package ( pull up resistors close to RTC chip)
1x 16MHZ crystal and two 22 ceramic capacitor
3x push buttons (2 pin push button)
1x electrolitic capacitor 10uF
2x 104 smd capacitors – one goes near crystal, one is below RTC
1x Toogle switch
1x cr2032 battery holder and battery

#MakeClock , #ClockProject #pcbway